Chapter 13 Keyframe Effects
832
Creating and Saving a Master Timeline
The display shows the register number last used for master timeline
operation.
6
Press the [STORE] button, turning it on.
7
With the numeric keypad buttons, enter the number of the register (here
“1”) in which you want to save the master timeline, and press the [ENTER]
button.
This saves M/E-1 register 10 and P/P register 5 in master timeline register
1, and the [STORE] button goes off. At the same time, the [RCALL]
button lights.
Checking the regions saved on a master timeline
For example in the course of changing a master timeline, you can check which
regions are saved in the register. With the [MASTR] button in the numeric
keypad control block lit, hold down the [STORE] button. While it is held down,
the buttons for the saved regions light. When the button is released, the state
before it was held down is restored.
Creating and Saving a Master Timeline Using the
Buttons in the Multifunction Flexi Pad Control Block
Creating and saving a master timeline
1
Press the [EFF] button, turning it on.
This assigns the memory recall section to keyframe effect operations.
2
Recall the register number of the effect you want to save on the master
timeline for each region. (See “Recalling a register from the numeric
keypad control block” (page 788).)
3
Of the region selection buttons, press those buttons for the regions you
want to save on the master timeline, turning them on.
4
Press the region selection button [MSTR], turning it on.
The display shows the number of the register last used for master timeline
register operation.
5
Press the [EDIT ENBL] button.
To Next Page
Loading...
