Chapter 13 Keyframe Effects
833
Creating and Saving a Master Timeline
This assigns the memory recall section to keyframe effect editing
operations.
6
Press the [STOR] button, turning it on.
7
With the numeric keypad buttons, enter the number of the register in which
you want to save the master timeline.
To find an empty register, instead of entering a number, press the [.]
(period) button.
The display shows the register number. If the number is followed by a
letter “E,” the register is empty.
8
Press the [ENTER] button.
The regions selected in step 3 and the register numbers recalled in those
regions are saved in the master timeline register.
Notes
• It is not possible to undo a master timeline save.
• Saving the master timeline does not carry out a save of effects. Save the
effects for each region first, then carry out the master timeline save.
Changing a master timeline
You can change information already saved in a master timeline.
As an example, to change the M/E-2 register from Effect 11 to Effect 15, use
the following procedure.
1
Recall the master timeline register you want to change. (See “Recalling a
register from the numeric keypad control block” (page 788).)
This simultaneously recalls M/E-2 register 11 and P/P register 11, and the
[M/E-2] and [P/P] region selection buttons light.
2
Press the region selection button [MSTR], turning it off.
3
Turn on only the button for the region you want to change (here, [M/E-2]),
and recall the desired register (here, Effect 15).
This recalls M/E-2 register 15, while on P/P register 11 remains selected.
4
Press the buttons for the regions you want to save on the master timeline
(here, [M/E-2] and [P/P]), turning them on.
5
Press the region selection button [MSTR], turning it on.
To Next Page
Loading...
