Chapter 14 Snapshots
859
Snapshot Operations in the Flexi Pad Control Block
For details of attributes, see “Snapshot Attributes” (page 849).
Notes
In the Flexi Pad control block, it is not possible to apply the cross-point
hold or GPI output attributes. In a simple type Flexi Pad control block, it
is not possible to apply any attributes. To add these attributes, use a menu
operation. (See page 869.)
5
Still holding down the [SNAPSHOT] button from step 4, press the
memory recall button corresponding to the register in which you want to
save.
Recalling a snapshot in the Flexi Pad control block (standard
type or simple type)
Notes
When an M/E bank is not assigned to any region selection button in the
numeric keypad control block in a setup setting, it is not possible to recall a
snapshot with the Flexi Pad control block of that M/E bank. (See “Assigning a
Region to a Region Selection Button in the Numeric Keypad Control Block” in
Chapter 19 (Volume 3).)
As an example, to recall a snapshot on the M/E-1 bank, use the following
procedure.
1
In the M/E-1 bank Flexi Pad control block, press the [SNAPSHOT] button.
This assigns the Flexi Pad control block to snapshot operations. The
numeric display shows the last selected bank number and the register
number last recalled on the bank.
2
Select the bank for recall.
See step 3 (page 858) in “Saving a snapshot in the Multifunction Flexi Pad
control block.”
3
To apply temporary attributes, press the following buttons, turning them
on.
To Next Page
Loading...
