Chapter 14 Snapshots
860
Snapshot Operations in the Flexi Pad Control Block
a) When Xpt Hold mode is selected in setup.
b) When Key Disable mode is selected in setup.
For details of the operation mode of the [XPT HOLD] button, see
“Selecting the Bank to Make the Settings” in Chapter 20 (Volume 3).
For details of temporary attributes and available attributes, see “Snapshot
Attributes” (page 849).
Notes
• The cross-point hold and key disable settings are maintained until you
next press the [XPT HOLD] button.
• Applying temporary attributes does not affect the contents of the
register.
4
Press the button in the memory recall section which shows the desired
register name.
The button you pressed lights yellow, and this recalls the snapshot.
The numeric display shows the selected register number after the bank
number.
Deleting a snapshot in the Flexi Pad control block (standard type
or simple type)
As an example, to delete a snapshot on the M/E-1 bank, use the following
procedure.
1
In the M/E-1 bank Flexi Pad control block, press the [SNAPSHOT] button.
This assigns the Flexi Pad control block to snapshot operations. The
numeric display shows the last selected bank number and the last recalled
register number on the corresponding bank.
2
Select the bank for the register containing the snapshot you want to delete.
Control block Temporary
attribute to apply
Button
Cross-point control
block
A/B bus cross-point
hold
[XPT HOLD] button in the
background A/B bus
Key cross-point hold
[XPT HOLD] button in the key bus
a)
Key disable
[XPT HOLD] button in the key bus
b)
Flexi Pad control
block
Effect dissolve [EFF DISS] button
Auto transition [AUTO TRANS] button
To Next Page
Loading...
