Chapter 16 Macros
932
Macro Operations in the Simple Type Flexi Pad Control Block
• In the simple type Flexi Pad control block, it is not possible to undo a macro
save.
Specifying an edit point
1
In the Flexi Pad control block, press the [MCRO] button, turning it on.
This assigns the Flexi Pad control block to macro operation.
2
While holding down the [MCRO] button in the Flexi Pad control block,
press the button in the memory recall section showing the desired register
name.
3
Specify the edit point by the following operation.
• To move the edit point to the event immediately following the current
macro event (the macro event specified as the current edit point), press
the [NEXT] button.
• To move the edit point to the event immediately preceding the current
macro event, press the [PREV] button.
Inserting an event
To add an event to an already created macro, use the following procedure.
1
Specify the edit point. (See page 932.)
2
Carry out the event to be added on the control panel.
For details of events that can be registered, see “Events” (page 902).
3
In the memory recall section, press the [INS] button.
This adds the new event after the event specified in step 1.
Modifying an event
1
Specify the edit point. (See page 932.)
2
Carry out the event you want to modify on the control panel.
3
Press the [MOD] button.
This modifies the event at the specified edit point as carried out in step 2.
To Next Page
Loading...
