Under the Main tab, the following information will display:
Note: Detailed information on the different parameters can be found in the sub
sequent GNSS topics.
Manufacturer/Model: The manufacturer and/or model of the GNSS receiver in your
SecureSync unit.
Validity: Status indicator lights for TIME and 1PPS signals: “On” (green) indicates a
valid signal, “Off” (red) indicates that no valid signal is available.
Receiver Mode:
Single Satellite: Used in areas with poor GNSS reception.
Standard:Default operating mode for the GNSS receiver.
Mobile: For non-stationary applications.
Receiver Dynamics: (u-blox receivers only); see "Select a setting and click Submit." on
page176.
Survey Progress: Real-time status:
ACQUIRING (x Satellites)—red
SURVEYING (x %)—yellow; remains at 1% if no satellites are in view
COMPLETE—green
Number of Tracked Satellites: The number of satellites currently being tracked.
Offset: As set by the user, in nanoseconds.
Antenna Sense:
OK (green)
Open: Check the antenna for the presence of an open.
Short:Check the antenna for the presence of a short.
Position: SecureSync’s geographic position by:
Latitude: In degrees, minutes, seconds
Longitude: In degrees, minutes, seconds
Altitude: In meters MSL (Mean Sea Level)
Receiver Constellation: (If equipped for Multi-GNSS reception) GPS/GLONASS/Ga
lileo/BeiDou/QZSS
Client A-GPS Status: A-GPS is ENABLED and running, or DISABLED
Client A-GPS Data: External A-GPS data is AVAILABLE, or UNAVAILABLE
Identified Satellite Signal Strengths: Bar graphs for all satellites detected. Color indic
ates signal strength.
168
CHAPTER 3 • SecureSync User Reference Guide Rev. 23
3.3 Managing References
To Next Page
Loading...