3.
SAASM GPS receivers are zeroized which deletes position, GPS data and keys.
Without valid keys the SAASM GPS only operates in L1 C/A mode like a com
mercial GPS receiver.
4.7.5.1 Physically Removing the CF Card
1.
Read the topic "SAFETY" on page33 and follow all applicable instructions pertaining to
safety and ESD compliance.
2.
Remove the top cover off the chassis.
3.
Locate the card socket on the main PCB.
4.
Remove the metal bar that holds the card in the socket.
4.7.5.2 Cleaning/Restoring
Starting in system software version 4.8.7 (see under TOOLS > SYSTEM: Upgrade/Backup), the
Compact Flash card can be modified in several different ways via Actions panel under TOOLS
> SYSTEM: Upgrade/Backup:
Restore Configuration: This will reset all user configurations to factory defaults with the
exception of networking settings and GPS position. Network settings can be changed, if
desired, via the Web UI, via the front panel, or the serial command line interface. The
GPS position can be deleted via INTERFACES > REFERENCES: GNSS0.
* Clean Configuration and Halt *: This will delete the network settings and the GPS pos
ition, as well as resetting all other user configurations to factory default. Alternatively,
"Clean" or "CleanHalt" can be initiated through the front panel or command line inter
face.
4.7 Resetting the Unit to Factory Configuration
CHAPTER 4 • SecureSync User Reference Guide Rev. 23
313
To Next Page
Loading...
Need help?
General