2.5 SAFETY
Caution: Do not ignore the Safety Instructions!
2.5.1 Safety: Symbols Used
Table 2-1:
Safety symbols used in this document, or on the product
Symbol Signal word Definition
DANGER!
Potentially dangerous situation which may lead to personal
injury or death! Follow the instructions closely.
CAUTION!
Potential equipment damage or destruction!
Follow the instructions closely.
NOTE
Tips and other useful or important information.
ESD
Risk of Electrostatic Discharge!
Avoid potential equipment damage by following ESD Best
Practices.
CHASSIS GROUND
This symbol is used for identifying the functional ground of an
I/O signal. It is always connected to the instrument chassis.
Analog Ground
Shows where the protective ground terminal is connected
inside the instrument. Never remove or loosen this screw!
Recycle
Recycle the mentioned components at their end of life. Follow
local laws.
2.5.2 SAFETY: Before You Begin Installation
This product has been designed and built in accordance with state-of-the-art standards and the
recognized safety rules. Nevertheless, its use may constitute a risk to the operator or install
ation/maintenance personnel, if used under conditions that must be deemed unsafe, or for pur
poses other than the product's designated use, which is described in the introductory technical
chapters of this guide.
Before you begin installing and configuring your SecureSync unit, carefully read the following
important safety statements. Always ensure that you adhere to any and all applicable safety
warnings, guidelines, or precautions during the installation, operation, and maintenance of
your product.
2.5 SAFETY
CHAPTER 2 • SecureSync User Reference Guide Rev. 23
33
To Next Page
Loading...
Need help?
General