Spectracom SecureSync 1200 - Checklist NTP Configuration; The NTP Setup Screen

2.15.1 Checklist NTP Configuration
The following is a list of configuration settings you may want to consider as you setup your NTP
Service. (Not all items may apply to your application, or there may be other considerations not
included in this list.)
1.
Did you setup your NTP Service and have it use the right Reference(s)?
See "NTP Reference Configuration" on page97.
2.
Does your NTP Service use the right Timescale?
See "NTP Output Timescale" on page95.
3.
If required, have you setup other NTP Servers and Peers for fallback purposes?
See "NTP Servers and Peers" on page99.
4.
Have you configured NTP Authentication and Access Restrictions (as needed)?
See "NTP Autokey" on page106, and .
2.15.2 The NTP Setup Screen
The NTP Setup screen provides access to all NTP configuration settings.
To open the NTP Setup screen, navigate to MANAGEMENT > NTP Setup. The NTP Setup
screen is divided into 5 panels:
90
CHAPTER 2 • SecureSync User Reference Guide Rev. 23
2.15 Configuring NTP