2.
Free up disk space, if needed:
Under Tools > Upgrade/Backup > Disk Status, check Percent Used: If the number is
greater than 70%, free up disk space.
(NOTE: If required, existing logs can be archived; for details consult the above-men
tioned instructions for updating SecureSync software.)
To free up disk space:
a.
Delete old log files: Tools > Upgrade/Backup > Disk Status > Clear All Logs.
b.
Delete old statistics files: [~] > Clear All Stats.
c.
Delete previous Upgrade files: Tools > Upgrade/Backup > Actions > Update
System > Delete Upgrade File(s). Note that Delete Upgrade File and Update Sys
tem cannot be selected at the same time.
3. Download the upgrade software bundle onto your PC.
4.
Check if you have any of the following option cards installed:
Simulcast (Model 1204-14)
PTP (Model 1204-12)
Gigabit Ethernet (Model 1204-06)
If this is the case, see above-mentioned instructions for updating SecureSync software
(unless this has been addressed at an earlier update).
5.
Perform the actual upgrade by navigating to TOOLS > Upgrade/Backup > Actions:
Update System File: Upload the upgrade software bundle previously downloaded onto
your PC (updateXYZ.tar.gz), and carry out the upgrade, as instructed.
6.
Verify that the upgrade was successful: Tools > Upgrade/Backup, confirm the new SW
version.
Note: In case the update failed, see "Troubleshooting Software Update" on
page327 for additional information.
4.6.2 Applying a License File
Software options like TimeKeeper, or Multi-GNSS must be activated by applying a license file:
Typically, SecureSync units are shipped with the license file pre-installed, reflecting the system
configuration as ordered. If a feature is to be activated after delivery of the SecureSync unit,
please contact Spectracom Support or your local representative to have a license file gen
erated. License files are archive files with a tar.gz extension. One license file may contain
multiple licenses for multiple products.
To apply the license file, you need to upload it into your SecureSync unit and install it:
1.
Save the license file license.tar.gz to a location on your PC (which needs to be
connected to the same network SecureSync is.)
304
CHAPTER 4 • SecureSync User Reference Guide Rev. 23
4.6 Updates and Licenses
To Next Page
Loading...