To change the time after which the WebUI will timeout:
1.
Navigate to the MANAGEMENT > Network Setup screen.
2.
In the Actions panel on the left, click on Web Interface Settings.
3.
In the Web Interface Settings window, enter the desired value in minutes.
In order for a new setting to take effect, you need to log off, and then log back in again. This
setting affects all users, i.e. not just the user changing the value.
4.4.2 Configuring the Front Panel
The front panel of the SecureSync unit comprises three elements which can be configured via
the SecureSync Web UI:
The keypad, which—in conjunction with the information display—can be used to access
SecureSync's main functions directly via the unit's front panel. To prevent inadvertent
keypad operation, it can be locked and unlocked from the Web UI. Learn more about
front panel keypad operation: "Keypad and Information Display" on page4.
The information display: A 4-line LCD display that can be configured to display dif
ferent screens, and that is used in conjunction with the keypad.
The LED time display which can be configured to show the current time (UTC, TAI, GPS
or Local timescale) in either 12- or 24-hour format. By factory default, the LED will dis
play UTC time in 24-hour format.
Accessing the Front Panel Setup Screen
SecureSync's Web UI allows you to configure the main elements on the front panel of the unit,
and to see an image of the information currently displayed on the 4-line front panel inform
ation display.
To access the front panel configuration window:
252
CHAPTER 4 • SecureSync User Reference Guide Rev. 23
4.4 Miscellanous Typical Configuration Tasks
To Next Page
Loading...
Need help?
General