Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
3.
Depending on which network protocol you are using (SSH, Telnet), you will need to
enter authentication upon establishment of the connection either in a separate authen
tication window, or the Terminal window: The default user name is spadmin, and the
password admin123.
4.
Using the Terminal window, you can now submit commands; see "CLICommands"
below for a list of commands.
5.3.2 CLICommands
SecureSync features a suite of command-line interface (CLI) commands that can be used to con
figure parameters and retrieve status information or log files via a remote connection, using the
telnet or ssh (if enabled) protocol.
This section includes a list of some of the supported commands.
Notes:
a.
The command “helpcli” will provide a list of all available commands and their syn
tax (Note: Typing “help” will output bash shell help only and will not provide useful
information).
b.
You can scroll up or scroll down through the output by using the Page Up/Page down
keys, or the arrow keys.
492 SecureSync User Reference Guide
APPENDIX
To Next Page
Loading...