Spectracom SecureSync 1200 - Page 107

Note: The panels will be disabled if you applied the optional TimeKeeper license,
and enabled TimeKeeper (MONITORING > TimeKeeper Service).
The NTP Servers and Peers panels
… are located on the right-hand side of the NTP screen:
NTP Servers: In this display you can view the NTP Servers that SecureSync detects in
your network. It is through this display that you configure external NTP references. See
"NTP Servers: Adding, Configuring, Removing" on page102.
NTP Peers: In this display you can view the NTP Peers that SecureSync detects in your
network. It is through this display that you configure NTP Peer reference inputs. See
"NTP Peers: Adding, Configuring, Removing" on page104.
For more information on NTP servers, clients, and Stratums see "NTP Servers and Peers" on
page99.
The NTP Throughput panel
… shows two graphs depicting the rate of NTP traffic from Clients and Server/Peers.
2.15 Configuring NTP
CHAPTER 2 • SecureSync User Reference Guide Rev. 23
91