Spectracom SecureSync 1200 - Page 499

Note: SecureSync starts numbering I/O ports with 0 (only 1PPS and 10MHz out
puts start at1, because of the built-in outputs).
The Status window displays the following settings:
Signature Control: Signature Control controls when messages will be broadcast in
response to events on the Event Input (J2) port when events are enabled and the card is
in “broadcast” mode. (Events are still queued even if they are not broadcast, and are
transmitted once the signature control conditions permit.) For more information on Sig
nature Control, see "Signature Control" on page136.
Format: The format of the message to be output. Refer to "ASCIITime Code Data
Formats" on page497 for a description of all of the available formats.
The Event Broadcast card only supports two formats (Event Broadcast Format 0 and Event
Broadcast Format 1), and only supports the output of one message per event. If format is
set to “None”, no messages will be queued in the Message Buffer.
Output Mode: When the output data will be provided. Available Mode selections are as
follows:
SecureSync User Reference Guide 483
APPENDIX