3.2.1.3 Manually Setting the Time
144
3.2.1.4 Using Battery Backed Time on Startup
146
3.2.2 Timescale Offset(s)
148
3.2.2.1 Configuring a Timescale Offset
148
3.2.3 Leap Seconds
149
3.2.3.1 Reasons for a Leap Second Correction
149
3.2.3.2 Leap Second Alert Notification
150
3.2.3.3 Leap Second Correction Sequence
150
3.2.3.4 Configuring a Leap Second
151
3.2.4 Local Clock(s), DST
152
3.2.4.1 Setting Up a Local Clock
152
3.2.4.2 DST Examples
154
3.2.4.3 DST and UTC, GMT
155
3.3 Managing References
155
3.3.1 Input Reference Priorities
155
3.3.1.1 Configuring Input Reference Priorities
157
3.3.1.2 The "Local System" Reference
160
3.3.1.3 The "User/User" Reference
161
3.3.1.4 Reference Priorities: EXAMPLES
163
3.3.2 The GNSS Reference
166
3.3.2.1 Reviewing the GNSS Reference Status
167
3.3.2.2 Determining Your GNSS Receiver Model
170
3.3.2.3 Selecting a GNSS Receiver Mode
172
3.3.2.4 Setting GNSS Receiver Dynamics
174
3.3.2.5 Performing a GNSS Receiver Survey
176
3.3.2.6 Configuring a GNSS Receiver Offset
178
3.3.2.7 Resetting the GNSS Receiver
179
3.3.2.8 Deleting the GNSS Receiver Position
180
3.3.2.9 Manually Setting the GNSS Position
181
3.3.2.10 GNSS Constellations
184
3.3.2.11 A-GPS
188
3.4 Holdover Mode
190
3.5 Managing the Oscillator
194
3.5.1 Oscillator Types
195
3.5.2 Configuring the Oscillator
196
3.5.2.1 About the "Time Figure of Merit (TFOM)"
196
3.5.2.2 About the "Phase Error Limit"
197
SecureSync User Reference Guide • TABLE OF CONTENTS
VII
To Next Page
Loading...