the Gear Icon in the GPSD Service panel allows you to change the Service Port
information. If your GPSD setup changes and needs to be reconfigured within
your VersaSync, this is where you can reset the service port.
2.
The Actions panel provides an option to restore the default configuration.
3.
The Receiver Status panel lists the information required by the GPSD service:
Device name
Mode, Time, Position, Track/Speed/Climb, Error Statistics, and Precision Stat-
istics
All satellites in view and the PRN, Elevation, Azimuth, Signal Strength, and Usage
for each satellite.
GPSD via CLI commands
The following CLI commands are used to control the behavior of GPSD via the VersaSync CLI:
gpsdserviceportget – Displays the GPSD service port
gpsdserviceportset – Sets the GPSD service port
There are two GPSD utility programs already incorporated into VersaSync; GPSpipe and
CGPS. Both can be used as commands within the CLI to view information currently being sent
via GPSD. Both commands use CTL + C to stop.
2.7 Configuring Network Settings
CHAPTER 2 • VersaSync User Manual Rev. 6.0
111
To Next Page
Loading...
