Spectracom VersaSync - Configuring Input Reference Priorities

Enabled—The reference is enabled.
Delete—Removes the Index (row) from the Reference Priority table.
3.3.1.1 Configuring Input Reference Priorities
VersaSync can use numerous external time sources, referred to as "references". As external time
sources may be subject to different degrees of accuracy and reliability, you can determine in
which order (= priority) VersaSync calls upon its external time and 1PPS references.
For additional information, see also "Input Reference Priorities" on page129.
Accessing the Reference Priority Screen
To access the Reference Priority Setup screen:
1.
Navigate to MANAGEMENT > OTHER: Reference Priority.
OR:
1.
On the HOME screen, click the GEAR icon in the Reference Status panel:
2.
The Configure Reference Priorities screen will display.
The Reference Priority screen is divided into 3 areas:
a.
The Actions panel, which provides a single action:
Restore Factory Defaults
b.
The Configure Reference Priorities panel, which displays the priority of VersaSync’s
references in a table form.
In this panel you can:
Add and configure new references
Delete references
Enable/disable references
Reorder the priority of VersaSync’s references
3.3 Managing References
CHAPTER 3 • VersaSync User Manual Rev. 6.0
131