Spectracom VersaSync - 4.8 Resetting the Unit to Factory Configuration

1.
Save the license file license.tar.gz to a location on your PC (which needs to be
connected to the same network VersaSync is.)
2.
Open the VersaSync WebUI, and navigate to Tools > Upgrade/Backup:
3.
In the Actions panel, click Apply License File.
4.
In the Apply License File window, click Upload New File.
5.
In the Upload File window, click Choose File. Using the Explorer window, navigate to the
location mentioned under the first step, select the license file, and monitor the installation
progress in the Status Upgrade window until the application has rebooted.
6.
Refresh the browser window, and login to the Web UIagain. Re-navigate to Tools >
Upgrade/Backup, and confirm that the newly installed Option is listed in the System Con-
figuration panel.
4.8 Resetting the Unit to Factory Configuration
In certain situations, it may be desired to reset all VersaSync configurations back to the factory
default configuration. The GNSS location, any VersaSync configurations and the locally stored
log files can be cleared via the Web UI.
Caution: It is not possible to clear the Authentication logs and NTP logs.
4.8 Resetting the Unit to Factory Configuration
CHAPTER 4 • VersaSync User Manual Rev. 6.0
223