Procedure:
1.
Connect the personal computer to the USB interface.
2.
Configure your terminal emulation program, using the following settings:
Port: COM1
Bits per second: 115200
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
3.
Depending on which network protocol you are using (SSH, Telnet), you will need to
enter authentication upon establishment of the connection either in a separate authen-
tication window, or the Terminal window: The default user name is spadmin, and the
password admin123.
4.
Using the Terminal window, you can now submit commands.
5.2.2 CLICommands
VersaSync features a suite of command-line interface (CLI) commands that can be used to con-
figure parameters and retrieve status information or log files via a remote connection, using the
telnet or ssh (if enabled) protocol.
This section includes a list of some of the supported commands.
VersaSync User Manual 241
APPENDIX
To Next Page
Loading...
