Figure 3-2: Host disciplining
Note: Host disciplining is NOT supported by VersaSync units that are equipped
with a Rubidium oscillator.
The Oscillators Settings page provides the user with some control of the disciplining process.
This page is also used to configure the length of time VersaSync is allowed to remain in the Hol-
dover mode when all references are lost.
3.4.1 Configuring the Oscillator
VersaSync is equipped with an internal oscillator. To configure the oscillator settings:
1.
Navigate to MANAGEMENT > OTHER: Disciplining.
2.
Click the GEAR icon at the top of the Status panel. The Oscillators Settings window will dis-
play:
172
CHAPTER 3 • VersaSync User Manual Rev. 6.0
3.4 Managing the Oscillator
To Next Page
Loading...
