Spectracom VersaSync - Restoring the Factory Defaults; Cleaning the Configuration Files and Halting the System

3.
Click OK in the grey confirmation window. The system will restore the configuration
using the bundled file stored at
/home/spectracom/xfer/config/VersaSync.conf, then reboot in order to
read the new configuration file. Once powered back up, VersaSync will be configured
with the previously stored file.
4.8.2.5 Restoring the Factory Defaults
For instructions on how to restore the VersaSync's configuration files to their factory default set-
tings see "Resetting All Configurations to their Factory Defaults" on page224.
4.8.3 Cleaning the Configuration Files and Halting the System
The "Clean and Halt" procedure restores the configuration files to their factory defaults and
then immediately halts the system, so as to prevent any changes from being applied to the fact-
ory default condition.
To perform a "Clean and Halt":
1.
Navigate to TOOLS > SYSTEM: Upgrade/Backup.
2.
In the Actions panel, click * Clean Configuration and Halt * .
4.8 Resetting the Unit to Factory Configuration
CHAPTER 4 • VersaSync User Manual Rev. 6.0
229