MAP
The map displays your current position, as reported by the GPS receiver. Should the displayed
position differ from the actual antenna position, the GPS signal is likely spoofed.
Note that the map data is not part of the BroadShield software, but is downloaded from the
Internet. Hence, this feature is only available if your VersaSync unit is connected to the Internet.
LOGS
To clear all current logs stored on VersaSync, click CLEAR LOGS.
To start a new log session, click NEW LOG SESSION.
To download current logs, click DOWNLOAD LOGS.
Broadshield Notifications
You can setup Notifications to be sent if BroadShield detects or clears an alarm:
Navigate to MANAGEMENT: OTHER > Notifications, and under the GPS tab, locate the
two BroadShield line items. For further information on how to configure Notifications,
see "Notifications" on page181.
146
CHAPTER 3 • VersaSync User Manual Rev. 6.0
3.3 Managing References
To Next Page
