Spectracom VersaSync - Page 255

Command Description
doyset Used to set the current Day of Year
gpsdop Displays GNSS receiver positional accuracy estimates
gpsdserviceportget Displays the GPSD service port
gpsdserviceportset Sets the GPSD service port
gpsinfo Applicable to SAASM-equipped VersaSync units only
gpsloc Displays GNSS latitude, longitude and antenna height
gpsmdl Displays the GNSS Manufacturer and Model
gpssat Displays GNSS satellites tracked and maximum signal strength being received
gw4get Displays
configured
IPv4 gateway addresses
gw4set Used to configure the IPv4 gateway addresses
gw6get Displays
configured
IPv6 gateway address
gw6set Used to configure the IPv6 gateway address
halt Used to Halt the system for shutdown
helpcli
Provides list of available commands and syntax
hostget Displays the DNS hostname
hostset Sets the DNS hostname
hotstart Initiate a hot start operation on the SAASM GPS receiver
ip4get Displays IPv4 Ethernet port
settings
information (IP address net mask and gateway)
ip4set Used to set IPv4 Ethernet port
settings
information (IP address net mask and gateway)
ip6add Used to add IPv6 Ethernet port
settings
information (IP address net mask and gateway)
ip6del Used to delete IPv6 IP address
ip6get Used to obtain the IPv6 IP address
iptables See
"Network Services" on page57
for more information.
licenses Displays configured licenses installed (if any)
list Outputs a list of commands
loadconf Restore a saved configuration and reboot
localget Used to obtain the configured local clock
locallist Used to display local clocks
VersaSync User Manual 243
APPENDIX