Steris Reliance EPS Endoscope Processing System - Page 106

5-5
Cycle and Control Value Programming Operator Manual 920011-649
3. Press ENTER touch pad to confirm selection. Display moves on
to WASH segment of selected cycle.
Display shows, for example:
__ blinking
and printer records, for example:
==========================
HH:MM:SS XM MM-DD-YY
==========================
MODIFY: SINGLE
==========================
4. Press SCROLL arrows (left or right) to change time value of
WASH 1 segment (adjustable from five to ten minutes).
NOTE: If a value is out of range, display shows OUT OF
RANGE–SEE OPERATOR MANUAL for four seconds, then
control returns to current display.
5. Press ENTER touch pad to confirm new WASH 1 segment time
value. Printer records:
============================
CYCLE MODIFICATION SAVED
============================
NOTE: For new values to be saved, it is necessary to scroll through
all phases of a cycle and confirm values by pressing ENTER touch
pad after each phase, even if no value was changed.
- or -
To cancel a modification, press ESC touch pad once. Display
returns to cycle being modified. Values are not saved. Printer
records:
============================
CYCLE MODIFICATION NOT
SAVED
============================
6. Display moves on to AIR PURGE phase time of selected cycle.
Display shows:
__ blinking
WASH
RECIRC MM:SS
AIR PURGE
RECIRC 0
4:00