Steris Reliance EPS Endoscope Processing System - Page 113

5-12
920011-649 Operator Manual Cycle and Control Value Programming
25. Press ENTER touch pad to confirm setting. Display shows:
__ blinking
26. REPEAT WASHING screen allows supervisor to choose if
WASHING phase (WASH segment followed by RINSE segment)
is to be performed once or twice during SINGLE endoscope
processing cycle WITH WASHING or DOUBLE endoscope
processing cycle WITH WASHING (see Table 5-1, Cycle
Description Chart).
Press SCROLL arrows (up or down) to enable or disable
REPEAT WASHING feature (YES = Operator can elect whether
or not to REPEAT WASHING phase; NO = Operator cannot elect
whether or not to REPEAT WASHING phase).
27. Press ENTER touch pad to confirm setting. Display shows:
__ blinking
28. WATER SAMPLING screen allows opening of chamber door
just before draining sub-phase of RINSE 2 phase (refer to
S
ECTION 4.10, WATER SAMPLING TEST, and Table 5-1, Cycle
Description Chart, for more details).
Press SCROLL arrows (up or down) to enable (YES) or disable
(NO) WATER SAMPLING option.
NOTE: When cycle is completed, water sampling option is
automatically cleared by processor. To perform another Water
Sampling, supervisor must set water sampling option to YES
again.
29. Press ENTER touch pad to confirm setting. Display shows:
__ blinking
30. CHEMICAL WARNING option is set to YES to warn operator
when remaining chemical volume is low. Only approximately five
more cycles can be processed before Bag-in-a-Box is empty
and Fault 08 or 09 is triggered (see S
ECTION 7,
TROUBLESHOOTING, for details on fault causes and solutions).
Cycle may be run without any notification or alarm. Purpose of
chemical warning is to advise operator that Bag-in-a-Box
container needs to be changed soon.
Press SCROLL arrows (up or down) to enable (YES) or disable
(NO)
CHEMICAL WARNING feature.
REPEAT WASHING
YES
WATER SAMPLING
YES
CHEMICAL WARNING
YES