Stratasys F120 - Page 162

Maintenance Schedule GrabCAD Print Method
Page 153
© Copyright 2020 Stratasys. All rights reserved.
Maintenance Schedule
Maintenance tasks must be performed on a regular basis in order to maintain optimal system
operation. Table 1 outlines the general maintenance schedule for the F120. Detailed
instructions for each task make up the rest of this chapter.
Table 2 lists part numbers for various replacement consumable items. Use the part numbers
listed in this table when ordering replacement parts from Stratasys or your regional Stratasys
of
fice.
Warning: Hot Surface Hazard
Always wear proper heat protective gloves and clothing when handling items inside
the oven, as surfaces within the oven can be very hot.
Table 1: Maintenance Schedule
Weekly Monthly As Needed Maintenance Task
X “Cleaning the Oven Chamber” (page 154)
X “Cleaning the Platen” (page 154)
X “Clean/Inspect Tip Wipe Assemblies” (page 154)
X “Cleaning the Exterior Surface of the Printer” (page 157)
X “Cleaning the Touchscreen Display” (page 157)
Table 2: Replacement Consumables
Part Number Description
123-00400 Model Head (standard)
123-00400 Support Head (standard)
123-00302 F170 substrate 1 box of 16
123-00305 Tip shield kit - 4 sets
123-00306
2-pack of tip wipe assemblies (see
“Clean/Inspect Tip Wipe Assemblies”
(page 154)).