Basic Setup Configuring the Network
Page 12
© Copyright 2020 Stratasys. All rights reserved.
Network Address Configuration
To configure your printer’s network address settings:
1. Power ON the printer, see
“Powering ON the Printer” (page 95).
2. Open the Tools page by pressing the T
ools button within the Navigation Menu (see
Table 1 (page 35)).
3. Open the Network page by pressing the N
etwork button within the Tools page (see
Figure 34 (page 69)).
4. The C
onnection Type row allows you to select between a wired or wireless network. The
option selected will determine the configurable settings displayed within the Network page.
• Selecting the W
ired option will allow you to select between a Dynamic or Static network
mode.
• Selecting the W
ireless option will configure the pinter to use a Wi-Fi network. You will
need to scan for a wireless network and enter the security settings for the selected
network (if required) to complete the configuration. Please note that the availability of
the Wireless option depends upon the configuration purchased with your printer.
5. After selecting the radio button corresponding to the connection type you’d like to use
(
wired or wireless) press the Back button in the upper-left corner of the page to return to
the Network page.
6. For wired networks:
a
. The N
etwork Mode row will be displayed. Press anywhere within this row.
b. Select either the S
tatic or Dynamic radio button to enable that network address type.
Depending on the option selected, you may need to configure additional information
within the Network page.
Figure 5: Wired Network Selection
• If the S
tatic option is enabled, you must manually configure the IP Address, Subnet
Mask, and Gateway Address fields.To configure this information simply touch a field on
the screen to select it and then use the keypad displayed to enter address information.
To Next Page
