Working with the Queue Page Adding a Job to the Job Queue
Page 49
© Copyright 2020 Stratasys. All rights reserved.
7. The Load File page will display the contents of the USB flash drive. Locate the desired job
and select it by touching its row on the screen; doing so will open its Job Details page.
Figure 17: Select File to Load
8. Within the Job Details page press the A
dd to Queue button; this will load the job into the
Job Queue.
Figure 18: Add File to Queue
If any USB port contain a flash drive, individual folder graphics will be displayed
on the screen representing each flash drive and its contents. Touching the folder
graphic on the screen will drill down into the folder and display its contents. If a
single flash drive is installed the job file(s) located on the flash drive will be
displayed in individual rows.
To Next Page
Loading...
