Stratasys Objet1000 Plus - Page 170

Objet1000 Plus User Guide 6 Operating and Maintaining the Objet1000 Plus 3DPrinter
DOC-06810 Rev.B 6-50
6. Inthefollowingscreen,selectReplacefaultyheads,andclickNext.
Figure6-66Procedureselectionscreen
Preparing the
Print Block
7. Selecttheprinthead(s)needingreplacement,andclickNext.
Figure6-67Headselectionscreen
Theprinterheatsandemptiestheprintblock,andpreparestheprinter.
(Thisshouldtakeupto30minutes.)
Figure6-68Printerpreparationprogressscreen