Stratasys Objet1000 Plus - Page 186

Objet1000 Plus User Guide 6 Operating and Maintaining the Objet1000 Plus 3DPrinter
DOC-06810 Rev.B 6-66
6. ClickDoneinthefinalwizardscreen.
Figure6-101Finalwizardscreen
Replacing the
UV Lamps
TheUVlampsusedforcuringmodelshavealong,butlimited,workinglife.
YoucantestandadjusttheireffectivepowerwiththeUVCalibrationwizard
(see"TestingandCalibratingtheUVLamps"onpage6-58).Ifyouneedto
replaceaUVlamp,followtheseinstructions:
1. Makesuretheprinterisinofflinemode.
Figure6-102Offlinemodeindicator(red)
Theonline/offline buttonatthebottomoftheprinterinterfaceshouldbe
red.Ifnot,clickittoswitchtheprintertoofflinemode.
Warning
Beforecontinuing,makesurethatthesafetyinterlockisnotdefeated,andthat
theUVlampisnothot.
2. StarttheUVLampReplacementwizardfromtheOptionsmenu.
3. Makesurethatthebuildtrayisempty,andconfirmthisinthewizard
screen.Then,closetheprinter,andclickNext.
Figure6-103Trayconfirmation