133
S
7. Reinstall any vertical separators or UL brackets into the extrusions (mentioned in in Section
17.5.3, Removing Extrusions).
8. Tighten all screws in the end modules.
17.8 Replacing the Motor
WARNING
Power should be cut
from the EP module,
Motor and other elec-
trical modules of the
service head prior to
removing any modules.
1. Dismantle the motor cover halves.
Terminal
Block
2. Remove the purple, blue, and brown wires.
3. Remove the cable clip at the capacitor. e
motor connection cable with now hang
loose.
4. Loosen three of the four Allen screws from
the top (shown in yellow) with a 4mm Al-
len wrench.
Caution Do not lose the re-
moved Allen screw.
5. Loosen the side Allen screw.
To Next Page
Loading...
