Stryker OSC400 - Cable Covers; Flat Panel;Light;Light Suspension; Light;Flat Panel Suspension - Teacup Installation

75
S
12.4 Cable Covers
12.4.1 Flat Panel/Light/Light Suspension
Cables
Rubber grommet
Flat Panel Monitor Cables
with Grommet and Cable Tie
1. Route the Flat Panel Monitor cables
through the one-inch opening in the down
tube and attach the down tube to the sus-
pension.
2. Rotate the upper extension arm in both
directions to ensure that sucient cable
remains outside the down tube.
e arm should be able to meet both limit
stops.
3. Pull the cables out of the down tube an
additional inch to ensure sucient cable is
available.
4. Wrap a split rubber grommet around the
cables and secure the grommet with a cable
tie.
e rubber grommet prevents the cables
from re-entering the down tube.
Assembled Cable
Cover
Assembled Cable Cover
5. Place the two halves of the Rotating Cable
Cover around the down tube to conceal the
cables.
6. Use two 6-sheet metal screws to attach the
halves together.
7. Use four 6-32 screws to attach the cover to
the base.
12.4.2 Light/Flat Panel Suspension - Teacup Installation
For SHA suspensions, fasten the dual suspension Flat Panel cable cover to the lowest Extension Arm
with four M3x8 screws.
For EHA suspensions, fasten the dual suspension Flat Panel cable cover to the lowest Extension Arm
with two M8x16 screws.