Need help?Do you have a question about the Stryker OSC400 and is the answer not in the manual?
General| Brand | Stryker |
|---|---|
| Model | OSC400 |
| Category | Medical Equipment |
| Language | English |
Guidelines for safe installation and operation to prevent equipment damage or injury.
Critical safety alerts and procedures, including electrical hazards and proper installation qualifications.
Procedures for installing both LED and Halogen light heads.
Steps for powering Halogen light systems.
Electrical and data connection procedures for Halogen lights.
Steps for powering LED light systems.
Detailed instructions for connecting the power supply box.
Connecting the power input to the power supply box.
Connecting control interfaces to the power supply box.
Connecting the wall control unit to the power supply box.
Initial setup procedures for the Visum LED system.
Connecting a laptop to the SIDNE port for system configuration.
Procedure for setting up a new Visum LED system installation.
Steps for installing flat panel or single panel monitors.
Procedures for adjusting the monitor yoke assembly.
Steps to adjust the width of the monitor yoke.
Steps to adjust the height of the monitor yoke.
Securing the monitor to the yoke assembly.
Procedures for balancing the monitor's center of gravity.
Adjusting the brakes to ensure monitor stability.
Adjustments for lights and flat panel arms.
Procedures for adjusting arm height.
Specific steps for adjusting standard spring arms.
Specific steps for adjusting low ceiling spring arms.
Adjusting the friction brakes on the boom arms.
Adjusting the overall brake force for arm movement.
Adjustments and configurations for boom arms.
Specific adjustments for OSC400 boom arms.
Specific adjustments for OSC600 boom arms.
Testing procedures after light and camera installation.
Overview and function of the electronic control system.
Servicing and troubleshooting the power supply box.
Guide for troubleshooting Halogen power supply box issues.
Servicing and understanding the wall control unit.
Wiring diagram illustrating the complete system connections.
Troubleshooting procedures for CAN bus communication issues.
Block diagram for troubleshooting light system problems.
General troubleshooting categories for boom systems.
Procedures for identifying and troubleshooting air leaks in the boom.
To Next Page
