Figures xiii
FIGURE 8-29 Internal Cables and DC Power Connector (SunCD 2Plus Drive-Type Chassis) 89
FIGURE 8-30 Back Panel SBus Slots and Captive Screws 90
FIGURE 8-31 SCSI Backplane, SCSI Data, and DC Power Connectors 90
FIGURE 8-32 Cable Guide Detail 92
FIGURE 8-33 Internal Cables and DC Power Connector (SunCD 4 Drive-Type Chassis) 94
FIGURE 8-34 Removing the System Board 95
FIGURE 8-35 Attaching a Wrist Strap to Back Panel and Removing the Power Supply 98
FIGURE 8-36 Internal Cables and DC Power Connector (SunCD 2Plus Drive-Type Chassis) 99
FIGURE 8-37 Back Panel SBus Slots and Captive Screws 100
FIGURE 8-38 Detail of Cable Guide 101
FIGURE 8-39 SCSI Backplane, SCSI Data, and DC Power Connectors 102
FIGURE 8-40 Internal Cables and DC Power Connector (SunCD 4 Drive-Type Chassis) 104
FIGURE 8-41 Back Panel Captive Screws 104
FIGURE 8-42 Removing the System Board 105
FIGURE 8-43 Diskette Drive Cable Location 109
FIGURE 8-44 Diskette Drive Cable Plastic Tab 109
FIGURE 8-45 Pulling the Diskette Drive Cable Through the Drive Bracket Opening 110
FIGURE 8-46 System Board Cable Routing (SunCD 4 Drive-Type Chassis) 112
FIGURE 9-1 Location of Hard Disk Drives 118
FIGURE 9-2 Single Connector Hard Disk Drive 119
FIGURE 9-3 Removing a Hard Disk Drive 120
FIGURE 9-4 Installing a Hard Disk Drive 122
FIGURE 9-5 Removing the CD-ROM Drive 124
FIGURE 9-6 SunCD 2Plus Rear View and Jumper Settings 125
FIGURE 9-7 SunCD 4 Drive Rear View and Jumper Settings 125
FIGURE 9-8 Installing a CD-ROM Drive 126
FIGURE 9-9 Diskette Drive Location 127
FIGURE 9-10 CD-ROM Drive Filler Panel 128
To Next Page
Loading...
Need help?
General
