Sun Microsystems SPARCstation 20 - 6 Power on and off; Removing Power from the System

45
CHAPTER
6
Power On and Off
Removing Power from the System
To remove power from the system:
Caution – Failure to terminate the operating system can cause data loss.
Note – Before turning off the system power, terminate the operating system.
1. Notify users that the system is going down (if networked system).
2. Back up the system files and data.
3. Shut down the system.
4. Ensure that the power is turned off to the monitor and all peripherals connected
to the system.
5. Remove DC power from the system by pressing the power-on/standby switch on
the back panel (
FIGURE 6-1).