Chapter 8 Removing and Installing Subassemblies 113
1. Route the diskette drive cable in the system chassis.
Note – The diskette drive cable should pass under the first metal cable clip in the
chassis floor.
2. Connect the diskette drive cable to the system board (
FIGURE 8-46).
3. Install the diskette drive.
See “Installing a Diskette Drive” on page 132.
4. Install the CD-ROM drive.
See “Installing a CD-ROM Drive” on page 124.
5. Detach the wrist strap and replace the cover.
See Chapter 7.
6. Power on the system.
See “Turning On the Power” on page 47.
To Next Page
Loading...
