6-10 CYLINDER HEAD, CYLINDER AND PISTON
• If the camshaft journal oil clearance measured exceeds the
limit, measure the inside diameter of the camshaft journal
holder and outside diameter of the camshaft journal.
• Replace the camshaft or the cylinder head depending upon
which one exceeds the specification.
" Camshaft journal holder I.D.:
Standard: (IN. & EX.): 22.003 – 22.025 mm
(0.8663 – 0.8671 in)
# 09900-20602: Dial gauge (1/1 000, 1 mm)
09900-22403: Small bore gauge (18 – 35 mm)
" Camshaft journal O.D.:
Standard (IN. & EX.): 21.959 – 21.980 mm
(0.8645 – 0.8654 in)
# 09900-20205: Micrometer (0 – 25 mm)
CAM CHAIN TENSION ADJUSTER
INSPECTION
• Remove the cam chain tension adjuster cap bolt, bar and
spring. (!6-4)
• Check that the push rod slides smoothly when releasing stop-
per
1.
• If it does not slide smoothly, replace the cam chain tension
adjuster with a new one.
To Next Page
Loading...
