CLUTCH 7-3
CLUTCH PLATE
REMOVAL
• Drain engine oil. (!2-12)
• Remove the brake pedal. (!16-18)
• Remove the clutch cover
1 and its gasket.
• Hold the clutch housing with the special tool.
" 09920-53740: Clutch sleeve hub holder
• Remove the clutch spring set bolts and clutch springs.
NOTE:
Loosen the clutch spring set bolts little by little and diagonally.
• Remove the pressure plate
2, bearing
3 and push piece
4.
• Remove the push rod
5.
NOTE:
If it is difficult to pull out the push rod
5, use a magnetic hand or
a wire.
CAUTION
Be careful not to damage the clutch housing or clutch
plates.
To Next Page
Loading...
