Suzuki RM-Z250 - TP Sensor Adjustment

12-18 FUEL SYSTEM
REMOVAL
• Remove the carburetor. (!12-5)
• Remove the throttle position sensor using the special tool.
$ 09930-11950: Torx wrench (T25)
INSTALLATION
• With the throttle valve fully closed, install the throttle position
sensor.
NOTE:
Align the throttle shaft end

A with the groove

B of throttle posi-
tion sensor.
• Adjust the throttle position sensor until resistance comes to
specification and tighten the mounting screw.
NOTE:
Make sure the throttle valve open or close smoothly.
% Throttle position sensor total of resistance:
4 – 6 kΩ (Bl – B)
% Throttle position sensor resistance:
When the throttle fully closed: 0.6 – 1.0 kΩ (Y – B)
When the throttle fully opened: 3.2 – 5.0 kΩ (Y – B)
$ 09900-25008: Multi-circuit tester set
09930-11950: Torx wrench (T25)
, Tester knob indication: Resistance (Ω)
• Install the carburetor. (!12-16)