12-12 FUEL SYSTEM
FLOAT HEIGHT
• Tilt the carburetor until the float arm
B just touches the float
valve rod.
• Measure the float height
A.
% Standard float height: 8 mm (0.31 in)
$ 09900-20101: Vernier calipers (150 mm)
• If necessary, slightly bend the float arm
B to change the float
height.
• Recheck the fuel level. (!12-11)
REASSEMBLY
Reassemble the carburetor in the reverse order of disassembly.
Pay attention to the following points:
• Make sure that the spring end
A is fitted on the pump lever
holder
1.
• Hook the return spring
2 to the acceleration pump lever
3.
• Fit the end of the return spring into the recess on the carbure-
tor body.
• Install the push rod
4 into the pump lever holder
B.
• Install the throttle stop screw
5.
To Next Page
Loading...
