Suzuki RM-Z250 - Page 196

FUEL SYSTEM 12-13
• Fit the float chamber.
• Tighten the screws with the hose plates

6 and cable holder

7.
• Apply THREAD LOCK to the plate mounting screws and
tighten them.
& 99000-32050: THREAD LOCK “1342”
• Fit the spring

8.
• Install the diaphragm

9 so that the marks

C face outside.
• Apply thin coat of the grease to the O-ring.
' 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
• Install the pilot screw

0.
NOTE:
Turn in the pilot screw

0 until it lightly seats, then back it out the
counted number of turns.
% Pilot screw: 1 and 1/2 turns back (Reference data)
45˚
CAUTION
Replace the O-ring and gasket with new ones to pre-
vent fuel leakage.
CAUTION
Replace the O-rings with new ones.
CAUTION
Replace the O-ring with a new one.