Suzuki RM-Z250 - Rear Wheel Removal

REAR SUSPENSION 18-17
INSTALLATION
Install the swingarm in the reverse order of removal. Pay atten-
tion to the following points:
• Install the following parts into the swingarm.

1 Oil seal

5 Washer

2 Spacer

6 Dust seal

3 Washer

7 Spacer

4 Thrust bearing
• Apply grease to the dust seals, bearings and oil seals.
% 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
• Apply THREAD LOCK SUPER to the plate mounting screws.
' 99000-32110: THREAD LOCK SUPER “1322”
(or equivalent thread lock)
• Tighten the plate mounting screws securely.
• Install the chain buffer.
• Install the swingarm.
• Tighten the swingarm pivot nut to the specified torque.
$ Swingarm pivot nut: 70 N·m (7.0 kgf-m, 50.5 lb-ft)
• Install the cushion lever and cushion rod.
• Tighten the cushion lever nut and cushion rod nut to the spec-
ified torque.
$ Cushion lever nut: 80 N·m (8.0 kgf-m, 58.0 lb-ft)
Cushion rod nut: 80 N·m (8.0 kgf-m, 58.0 lb-ft)
• Install the rear wheel. (! 15-11)
• Adjust the drive chain slack. (!2-28)