Suzuki RM-Z250 - Electrical System

17-18 FRONT FORK AND STEERING
STEERING
REMOVAL
HANDLEBARS
• Place the motorcycle on a block to lift front wheel off the
ground.
• Remove the front number plate and protector. (!17-4)
• Remove the clamps.
• Remove the engine stop switch

1.
• Remove the clutch lever holder.
NOTE:
Mark the paint marks to the matching surfaces of clutch lever
holder and handlebars, left handle grip and handlebars.
• Remove the left handle grip

2.
• Remove the front brake master cylinder.
NOTE:
Mark the paint mark to the matching surface of master cylinder
holder and handlebars before removing.
• Remove the throttle case screws.
NOTE:
Mark the paint mark to the matching surface of throttle holder
and handlebars before removing.
• Slightly loosen the handlebar holder set nuts.