13-8 COOLING SYSTEM
OIL SEAL
• Visually inspect the oil seal for damage.
• If any defects are found, replace the oil seal with a new one.
INSTALLATION
Install the water pump in the reverse order of removal. Pay
attention to the following points:
OIL SEAL
• Apply THREAD LOCK SUPER to the outer surface of the oil
seal.
% 99000-32110: THREAD LOCK SUPER “1322”
(or equivalent thread lock)
• Press the oil seal with the suitable size socket wrench.
• Apply a small quantity of the SUZUKI SUPER GREASE to the
oil seal lips.
& 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
IMPELLER AND WATER PUMP SHAFT
• Hold the water pump shaft with a wrench and tighten the
impeller to the specified torque.
! Impeller: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
CRANKCASE COVER
• Install the dowel pins and gasket
1.
CAUTION
Use a new gasket to prevent engine oil leakage.
To Next Page
Loading...
