Suzuki RM-Z250 - Oil Seal Removal and Installation; Bearing Inspection

TRANSMISSION AND CRANKSHAFT 10-9
OIL SEAL REMOVAL AND INSTALLATION
• Remove the oil seals (

1,

2,

3,

4) with the special tool.
" 09913-50121: Oil seal remover
• Install each new oil seal with the special tool.
" 09913-70210: Bearing installer set
Oil seal

1,

4: $ 40 Attachment
Oil seal

2: $ 22 Attachment
Oil seal

3: $ 17 Attachment
• Apply grease to each oil seal lip.
% 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
NOTE:
Be sure to check the direction of the crankshaft bearing oil seal

4 before installing them.
BEARING INSPECTION
• Inspect the bearings for play, discoloration, wear and seizure.
• Move the inner race by finger and inspect for smooth move-
ment.
• If it does not move smoothly, replace the bearing with a new
one.
CAUTION
The removed oil seal should be discard.
PRIMARY
DRIVE
GEAR
SIDE