Suzuki RM-Z250 - Inspection; Dust Seal and Bearing Replacement

15-8 FRONT AND REAR WHEELS
INSPECTION
WHEEL SPACER
• Remove the wheel spacers from the rear wheel.
• Inspect the rear wheel spacers

1 and dust seals

2 for wear
and cracks.
• If any defects are found, replace the spacer together with the
dust seal.
NOTE:
Apply grease on the spacer and dust seal before reassembling.
SPROCKET
• Inspect the sprocket teeth for wear.
• If they are worn as shown, replace the two sprockets and
drive chain as a set.
AXLE SHAFT ('15-3)
WHEEL RIM (' 15-4)
WHEEL BEARING ('15-4)
DUST SEAL AND BEARING REPLACEMENT
• Remove the dust seals with the special tool.
" 09913-50121: Oil seal remover
• Remove the snap ring

1.
" 09900-06108: Snap ring pliers
Normal wear
Excessive wear
CAUTION
The removed dust seals must be replaced with new
ones.
CAUTION
The removed snap ring must be replaced with a new
one.