Suzuki RM-Z250 - Installation

ELECTRICAL SYSTEM 14-13
• Remove the magneto rotor with the special tool.
! 09930-35020: Rotor remover
• Remove the magneto rotor key

5.
INSTALLATION
• Remove any grease from the tapered portion

A of the mag-
neto rotor and crankshaft

B.
• Fit the magneto rotor key

1 into the crankshaft.
• Install the magneto rotor.
• Tighten the magneto rotor nut to the specified torque with the
special tool.
! 09930-44560: Rotor holder
( Magneto rotor nut: 80 N·m (8.0 kgf-m, 58.0 lb-ft)
• Install the dowel pins and gasket

2.
CAUTION
Replace the gasket

2 with a new one.