FRONT AND REAR BRAKES 16-13
• Remove the dust boot
5 and snap ring
6.
' 09900-06108: Snap ring pliers
• Remove the washer
7 and piston/cup set
8.
MASTER CYLINDER INSPECTION
• Inspect the cylinder bore and piston for scuffing, wear and
damage.
• Inspect the piston rod and spring for damage.
• Replace the defective parts with a new one.
MASTER CYLINDER CLEANING
• Flush the master cylinder ports with pressurized air.
• Wash the master cylinder bore and piston with fresh brake
fluid.
! Specification and classification: DOT 4
NOTE:
Do not use gasoline or other cleaning solvents to wash the mas-
ter cylinder parts.
To Next Page
Loading...
