SERVICING INFORMATION 19-29
HANDLEBAR SET-UP
Assemble throttle cables as to show this drawing.
Throttle cable
(Pull side)
2.2 mm (0.087 in)
55˚
30˚
105˚
66˚
A
VIEW A
Marking on drawing position.
Match slit of throttle case with marking.
Apply adhesive to inner of grip
and handlebars.
Marking on drawing position.
Match “ ” mark of grip (L) with marking.
Throttle cable
(Return side)
Upper side
Upper side
Marking on drawing position.
Match slit of handlebar holder with marking.
Marking on drawing position.
Match slit of master cylinder
with marking.
Position of velcro : backward
Marking (Left front side)
Upper side
Make the cut-line of
collor to lower side.
Put the boot of throttle cable on throttle case.
Marking on drawing position.
Match slit of clutch lever
with marking.
Upper side
Upper side
10 – 12 mm
(0.39 – 0.47 in)
Approx. 3 mm (0.12 in)
To Next Page
Loading...
