Suzuki RM-Z250 - Dust Seal and Bearing Replacement

15-4 FRONT AND REAR WHEELS
WHEEL RIM
• Measure the wheel rim runout with the dial gauge.
• If the runout exceeds the limit, replace the bearings or wheel.
! Service Limit: 2.0 mm (0.08 in) ... axial and radial
" 09900-20607: Dial gauge (1/100, 10 mm)
09900-20701: Magnetic stand
WHEEL BEARING
• Turn the inner race by finger and inspect it for smooth move-
ment.
• Inspect for bearing damage.
• If any defects are found, replace the bearing with a new one.
DUST SEAL AND BEARING REPLACEMENT
• Remove the dust seals with the special tool.
" 09913-50121: Oil seal remover
• Remove the bearings with the special tool.
" 09921-20240: Bearing remover set (Remover 20 mm)
• Remove the spacer.
CAUTION
The removed dust seals must be replaced with new
ones.
CAUTION
The removed bearings must be replaced with new
ones.